No announcement yet.

Brightness setting on lights

  • Filter
  • Time
  • Show
Clear All
new posts

    Brightness setting on lights

    I often use basic bulbs as "indicators" to show that something has power. But sometimes I have too many in a small area which causes that area to be so overly bright that it is just stupidly unpeasant to look at.

    I wish I could set them to a lower value, eg 20%.

    How hard would it be to create a light-bulb with a brightness setting?

    If that is difficult, then how about just version of the basic bulb that gives a very low light (and ideally uses less power).

    What would have been even better would be an indicator panel that shows say up to 4 other specific things to show whether they are on or off ... but that Iimagine is in a different league.

    Ah, in the mean time I can use switches. Don't HAVE to connect the output to anything, it has a light that shows that it is receiving power so it can be my power available indicators.